1. After unpacking, first check whether the equipment is damaged in transit, then put the high-machine and auxiliary electrical control devices in place, and then connect the main and auxiliary machine's pipe roads. The seal is painted with “Iron Anchor 609†liquid sealant to ensure the tightness of the pipeline. At the same time, each single machine and pipe flange are connected by grounding wire and grounded to avoid dust explosion caused by static spark.
2. Before each single machine is tested, check whether there are metal objects in the machine. If there is any, remove it. Whether the bolt is firm, the tightness of the belt, the reliability of the shield, etc.
3. Start each motor in the following sequence, close the damper start, pulverizer->duster->classification device->screw feeder->open damper->closer.
4. After five minutes of empty car operation, the operator should carefully observe the various instruments on the control cabinet and wait until the no-load current is stable before feeding. After the feeding, the current is not allowed to exceed the rated value of 32.6A. Otherwise, the amount should be reduced to ensure that the normal operation of the discharge electric can work regularly.
5, can be stopped in the following order
Screw feeder -> After five minutes of operation, the main engine can be stopped, dust collector, classifier -> air locker.
6. Operate the stepless shifting handle of the classifier to change the speed of the classifying wheel and at the same time achieve the fine adjustment of the product. If the product size is required to be fine, the rotation speed can be increased, and vice versa, the particle size can be increased.
Wirelless Fire Alarm System,Wireless Fire Sounder,Wireless Fire Detection,Wireless Smoke Detector
LIAONING YINGKOU TIANCHENG FIRE PROTECTION EQUIPMENT CO.,LTD , https://www.tcfiretech.com